Original 2.5G SFP Module Overview

You may be want a 2.5G SFP module for your network, follow this page to learn more about original 2.5G SFP module supplied by us.

2.5G SFP transceiver module provides a low cost high-performance connection, which is also known as OC-48 or STM-16.

Our Multi-rate Series 2.67Gb/s transceiver module integrates optics and electronics in a Small Form Factor Pluggable (SFP) package. The 2.5G SFP transceiver provides a complete 2.5G SONET interfaces compatible with SONET/SDH optical layer and layer.

Its' microprocessor - based on a modular design to achieve all of the functions specified in the SFP MSA compatible 2-wire serial digital diagnostic monitoring interface optical transceiver.

The 2.5G SFP transceiver is a network line with transmission speeds of up to 2488.32 Mbit/s (payload: 2405.376 Mbit/s (2.405376 Gbit/s); overhead: 82.944 Mbit/s). With relatively inexpensive interface prices, and being faster than OC-3, OC-12 SFP connections, and even surpassing gigabit Ethernet, OC-48 connections are used as the backbones of many regional ISPs.

The 2.5G SFP capabilities on the Cisco ONS 15600 Series consist of two optical line cards, providing interface specifications that meet the varied application needs of the service provider. Interconnections between large ISPs for purposes of peering or transit are quite common.

2.5Gbps OC48 1310nm 20km SFP Optical Transceiver

As of 2005, the only connections in widespread use that surpass 2.5G speeds are OC-192 and 10 Gigabit Ethernet. 2.5G is also used as transmission speed for tributaries from OC-192 nodes in order to optimize card slot utilization where lower speed deployments are used. Dropping at OC-12, OC-3 or STS-1 speeds are more commonly found on OC-48 terminals, where use of these cards on an OC-192 would not allow for full use of the available bandwidth.

The 2.5G SFP module are compatible with the Small Form Factor Pluggable Multi-Sourcing Agreement (MSA). The standard serial ID information compatible with SFP MSA describes the transceiver’s capabilities, standard interfaces, manufacturer and other information. The host equipment can access this information via the 2-wire serial bus.

Sopto is a top-10 fiber optic manufacturer. We supplies high quality fiber optical modules compatible with Cisco, HP, HUAWEI, Finisar and so on. For the newest quotes, please contact a Sopto representative by calling 86-755-36946668, or by sending an email to info@sopto.com. For more info, please browse our website.