E1 to N x ETH Converter

The E1 to N x Ethernet converter also as FE1 to Ethernet Bridge, it is mainly accomplished the converting between the Nx100M Ethernet ports and the E1 port. E1 interfaces conforming to ITU-T G.703 and G.704 proposals are provided at the end of WAN, supporting RJ45 and BNC connection modes. The Ethernet is an extended device; the FE1 to Ethernet Bridge realizes interconnection of two Ethernet by using the E1 channel provided by existing networks with low cost.

FE1 to Ethernet interface converter adopts telecom line (E1 or E1 transmitting network, such as PDH, SDH, microwave, etc.) to extend Ethernet. It converts Ethernet frame structure to E1 frame structure, and recovers E1 frame structure to Ethernet frame structure at the other side, which enables Ethernet data to transmit in telecom network based on E1. Because it effectively used the spare bandwidth of telecom providers, it saves the networking cost and improves the efficiency and can be used immediately…[Details]

Feature:

1. Support 10Base-T, 100Base-T
2. Power supply AC-220V or DC-48V
3. Provide local E1 loop, remote E1 loop functions
4. E1 interface uses PCM31 mode, supporting CRC check
5. Support AUTO-MDIX, straight and crossover auto-adapt
6. E1 interface main/ slave clock optional in the framing mode
7. According with IEEE 802.3, 802.3u Ethernet and G.823 protocols
8. Support E1 channel hot plug, and auto detect available E1 channels

Related Knowledge:

Remote Ethernet Media Converter

How to use Power over Ethernet Kid?

Media converter Internal Composition

Using Attention of Fiber Media Converter

Benefit from Ethernet Fiber Media Converter