- Fiber Optic Transceiver Module
- High Speed Cable
- Fiber Optical Cable
- Fiber Optical Patch Cords
- Splitter CWDM DWDM
- PON Solution
- FTTH Box ODF Closure
- PCI-E Network Card
- Network Cables
- Fiber Optical Adapter
- Fiber Optical Attenuator
- Fiber Media Converter
- PDH Multiplexers
- Protocol Converter
- Digital Video Multiplexer
- Fiber Optical Tools
- Compatible
- Can SFP+120KM be available? ...
- Why the price has so huge di...
- Can XFP transceiver modules ...
- Must optical fiber jumper be...
- Is there a module which can ...
- Can different brands SFP tra...
- How long will you change you...
- The difference between DDM S...
- Comparison of EPON and GPON
- Should we use 3rd party’s ...
- How to make differences betw...
- What is Drop Cable?
- Comparison of CWDM and DWDM ...
- GEPON Technology
- Differences of OM1, OM2, OM3...
- What is the armored fiber op...
- What is DAC cable?
- How to Choose A Right Fusion...
- Why Using a Compatible SFP O...
- Optical fiber transmission l...
What is GBIC?
What is GBIC?
A gigabit Interface converter (GBIC) is a standard for transceivers , commonly used with Gigabit Ethernet and fibre channel in the 1990s. By offering a standard, hot swappable electrical interface, one gigabit port can support a wide range of physical media, from copper to long-wave single-mode optical fiber, at lengths of hundreds of kilometers.
A variation of the GBIC called the small form-factor pluggable transceiver (SFP), also known as mini-GBIC, has the same functionality but in a smaller form factor. Announced in 2001, it largely made the GBIC obsolete.
Appeal
The appeal of the GBIC standard (and hot-swappable transceivers in general) in networking equipment, as opposed to fixed physical interface configurations, is its flexibility. Where multiple different optical technologies are in use, an administrator can purchase GBICs as needed, not in advance, and they can be the specific type needed for each link. This lowers the cost of the base system and gives the administrator far more flexibility. On the other hand if a switch will mostly have one port type (especially if that port type is copper) purchasing a switch with that port type built in will be cheaper and take up less space per port.
Standards
The GBIC standard is non-proprietary and is defined by the Small Form Factor committee in document number 8053i.The first publication of the proposal was in November 1995. A few corrections and additions were made through September 2000. Robert Snively of Brocade Communications was technical editor. Original contributors were AMP Incorporated, Compaq Computers, Sun Microsystems, and Vixel Corporation.